PicoBNC+ Automotive 10:1 scope probe & adaptor

$76.00

The compact design of the TA506 contains the entire attenuator circuit of a traditional oscilloscope probe, but within a 4 mm connector body. With a fixed x10 attenuation it is intended for high-speed signals like CAN, FlexRay and also for higher voltage signals such as primary ignition.

The TA506 is automatically recognised by PicoScope software when connected to the scope. This accessory is only available for PicoBNC+ and will not work with older PicoScope models.

(TA506 is replacing the former TA499 for improved signal measurement flexibility.)

Quantity:
Add To Cart

The compact design of the TA506 contains the entire attenuator circuit of a traditional oscilloscope probe, but within a 4 mm connector body. With a fixed x10 attenuation it is intended for high-speed signals like CAN, FlexRay and also for higher voltage signals such as primary ignition.

The TA506 is automatically recognised by PicoScope software when connected to the scope. This accessory is only available for PicoBNC+ and will not work with older PicoScope models.

(TA506 is replacing the former TA499 for improved signal measurement flexibility.)

The compact design of the TA506 contains the entire attenuator circuit of a traditional oscilloscope probe, but within a 4 mm connector body. With a fixed x10 attenuation it is intended for high-speed signals like CAN, FlexRay and also for higher voltage signals such as primary ignition.

The TA506 is automatically recognised by PicoScope software when connected to the scope. This accessory is only available for PicoBNC+ and will not work with older PicoScope models.

(TA506 is replacing the former TA499 for improved signal measurement flexibility.)

PicoBNC+ 14 bar pressure transducer with Foster adaptor
$420.00
Premium Test Leads: Set of four leads 3 m (TA125 - TA128)
$218.00
Premium Test Lead: PicoBNC+ to 4 mm, 3 m
$65.00
Insulated BNC to insulated BNC 5 m
$36.00
Keyless entry carrier signal detector
$34.00